Причіп з робочою платформою

MÜLLER-MITTELTAL 3-Achs Plateau, luftgefedert, hydr. Rampen

* PT 30 Profile:
* EBS (electronic braking system)
* Emergency release device for spring brake cylinders
* Drum brakes
* 3 x 11 t Gigant axles
* Air suspension with lift and lowering feature as well as RtR-valve
* Smart-Board mounted on the trailer as an infotool (for axle load display – front and rear display separated)
* Tire pressure monitoring with display functionality in the truck via EBS signal, no truck-side installation required
* Side underrun protection
* Swivel supports at the rear of the chassis frame
Kljdpfx Agetplwij Nop
* Mechanically adjustable warning sign packs at the front and rear
* Front axle plastic quarter mudguards with splash protection
* Rear axle straight galvanized steel plate skirts with splash protection
* Reflective contour tape on the sides and rear
* 15-pin power connector
* LED lighting 12 / 24 V
* Rear LED rotary beacon (removable)
* 1,200 mm long drawbar with 40 mm towing eye and height adjustment via draw spring & turnbuckle
* Tool box made of galvanized sheet steel approx. 650 x 300 x 600 mm, black powder-coated, mounted on the right side
* Accessory box in the bogie frame with folding lid, 2 fixed container locks (directly after the bogie platform)
* ROBOT welded anti-slip coating on the bogie platform steel plate (protruding welding seams)
* Load securing package consisting of: 2 lashing eyes (13.4 t) front left & right on the front wall bracket, 1 pair each front & rear UVV lashing rings (13.4 t), and 3 pairs each side UVV lashing rings (10 t), swiveling and lowerable, loadable in all directions and recessed in the outer frame, 3 stake pockets each side with simultaneous 2 t lashing provision
* 6 pairs of mechanical folding outriggers for 3 m overall width (not in the rear slope)
* Widening planks stored in the center of the load floor
* Hydraulic one-piece drive-on ramps approx. 3,000 x 720 mm
* Mechanically adjustable sideways
* 4-way control block for later retrofit of hydraulic ramp shift
* Continuous excavator arm rest above the rear axle up to the end cross member (total length approx. 2,100 mm)
* 2 pairs of lashing eyes LC 6,400 daN in the excavator arm rest, laterally in the longitudinal frame
* 2 galvanized steps on the bogie left & right
* Profifix lashing rail in the longitudinal axis center, in flush area for lashing capability up to LC 3,000 daN
* Chassis, bogie, folding outriggers, drop supports, and ramps hot-dip galvanized
* Axles, slewing ring, air tank, and drawbar painted black
* Load edge (loaded) approx. 910 mm +/- 20 mm with air suspension
* New vehicle with manufacturer’s warranty
* Errors and prior sale excepted
* Available from approx. CW 22/2026
* Sample images

Оголошення було перекладено автоматично. Можливі помилки перекладу.