Низьконавантажувач

Fliegl Tandem-Tiefbett-Anhänger TTS 100 4,5m

Custom-made transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are carried out individually according to customer requirements.

Chassis: Central axle trailer, low-bed
Fine-grain steel welded construction
Gear-supported front leg
Telescopic rear support
2 chock blocks with holder
Fenders made of sheet steel over both wheels
Side impact protection, aluminum
Coupling device for central axle trailer
Drawbar with tested 40 mm towing eye
Drawbar height-adjustable via spindle, max. adjustment range 250 mm
Axles + Suspension
BPW drum brake axles
"Axle/chassis laser-aligned" – reduces tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearing and mechanical axle load equalization (rocker equalization)
Wheels and tires
235 / 75 R 17.5"
according to manufacturer's choice
Steel rims, factory silver
Braking system
2-line compressed air braking system
Spring-loaded parking brake
Nodpfx Aoi Ri Ebokhswh
2 fail-safe coupling heads at the front, with connection lines to the towing vehicle
24 Volt ABS and ALB, with ABS connector at the front, with connection cable
Note: The trailer may only be towed by towing vehicles that ensure the effectiveness of the ABS!
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red marker lights at the rear
2 x 7-pole fail-safe plugs at the front, with connection cable
Platform TTS
Low-lying steel pan, platform floor made of steel/diamond plate, steel walls solidly welded to the floor
Platform length 4500 mm
Pan front and side with "Load-Lock profile" for attaching lashing straps
(8 pieces at the front, 12 pieces on each side)
Note: Slight floor waviness due to welding distortion is possible!
2 pairs of lashing eyes, 1 x at the front in the corners of the steel pan and 1 x at the rear in the floor, each 5 tons.
Ramps
Steel ramps, 2,300 mm long, 510 mm wide, laterally movable
with handrail on the ramps
covered with wood (tip area with steel/diamond plate)
with gas spring for single-person operation
Operating instructions
The specified total weight is technically possible; depending on the load, the total weight may not be reached while complying with the permissible axle/support and saddle loads. (Poor driving and tracking behavior possible due to incorrect load distribution)
Country of approval/signs
Country of approval: Germany
with Dekra approval and certificate (according to §13 EG - FGV)
24/7 service hotline
prepared for single-row license plate holder
Contour marking with reflective tape according to ECE R 048, white on the sides and red at the rear
Painting
Frame painted or galvanized, according to customer requirements
Ramps, hot-dip galvanized

Custom-made transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are carried out individually according to customer requirements.

Оголошення було перекладено автоматично. Можливі помилки перекладу.