Прогулянкова підлога

Fliegl SDS 390 Schubboden

Additional information
Chassis
Fine-grained steel welded construction in lightweight design, extending to the support legs; kingpin plate with 2 replaceable kingpins
Lateral floor preparation for lashing eyes
24-ton, two-speed support legs, single-sided operation, with straight lower part, without shock absorption
Extendable ladder at the rear
Door latch on the side
2 wheel chocks with holder
Aluminum side impact protection
Steel underrun protection with wide Fliegl mud flaps; foldable mudguard for lighting unit
Quarter panel fenders
Rear impact protection
Aluminum ladder approx. 3,550 mm, with holder on the side
Tarpaulin rod with holder
1 plastic toolbox, with drawer and insert, b=650 / h=520 / d=670 mm, lockable with a padlock (padlock not included)
1 spare wheel holder for 1 spare wheel, with wheel fastening kit
Axles + Suspension
SAF disc brake axles with 430 mm disc diameter
Axle/suspension laser-aligned to reduce tire wear and fuel consumption
Air suspension
1st axle: automatic lift axle, including forced lowering and starting aid, actuated by 3x braking (starting aid functional up to an axle load exceeding 30% and a speed of max. 25 km/h)
Braking system
2-line compressed air braking system; color-coded lines for easy maintenance
Spring brake parking brake
2 fail-safe coupling heads at the front, without connection line
EBS, Electronic Braking System with EBS socket at the front, without connection cable
With raise and lower valve
Vehicle - Driving stability system
Wheels and tires
385/55 R22.5, according to manufacturer's choice
Steel rims, factory silver
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the side
2 white position lights at the front
2 white/red side marker lights at the rear
2 x 7-pin and 1 x 15-pin fail-safe sockets at the front, without connection cable
Sliding floor hydraulics
Hydraulic cylinder with sliding mechanism installed in the floor; 2-circuit hydraulic system
Switching between forward/backward movement electrically via remote control with cable
- Sliding floor power supply via parking lights
Actuation hydraulically via truck PTO
Hydraulic connection with hose at the front wall and HDK screw connector NW = 48 mm
Note: A 2-circuit hydraulic system is required!
Recommended pump output:
Flow rate: 110 l/min
Pressure: 250 bar
Minimum oil tank filling: 100 l
Sliding floor
Sliding floor with wear plate at the rear
Floor boards made of aluminum, 8 mm floor profile, ribbed design
Tipping body
Aluminum tipping body made of high-quality, abrasion-resistant material. Front and side walls made of aluminum hollow profiles, welded together at the top all around with a wide special reinforcement profile made of aluminum, welded to a special frame at the bottom.
Lhjdpfx Ansi Riywoxjh
Sliding wall for better unloading of the load, with reinforced tarpaulin flaps at the bottom
with rail cleaner
Rear wall made of aluminum hollow profiles, as a 2-wing door, with a division of 1/2 to 1/2, framed all around with a special U-profile with stop and rubber seal, with 2 pieces of externally mounted swivel bolts, locked at the top and bottom. Rear wall with mechanical safety locking, operation at the rear on the driver's side. With pivoting crossbar at the top. The door locks can be locked with a padlock.
Standing platform with access ladder on both sides in driving direction left/right and railing, for opening

Оголошення було перекладено автоматично. Можливі помилки перекладу.