Трьохсторонній самоскидний причіп

FLIEGL TSK 118 Tandem Dreiseitenkipper 5,0m Kipp Anhäng

Further information

plus delivery/preparation from storage location 26639 Wiesmoor €1,280.00 / net

Chassis Central Axle Tipping Trailer
Steel welded construction, continuous tipping shaft at the rear with 80 mm ball bearing mount
Front support leg with gearbox
Foldable rear support
2 wheel chocks with holder
Steel underrun protection
Full-width rear mud flaps
Quarter shell fenders
1 plastic toolbox, width=600 / height=425 / depth=460 mm, lockable
Note! Sidewall touches the storage box when folded down.
Lockable storage compartment for loading ramps underneath the loading area
Central axle trailer drawbar arrangement
Drawbar with certified 40 mm towing eye
Drawbar height adjustable via spindle, adjustment range max. 300 mm

Axles/Suspension
GFA drum brake axles
"Axle / Chassis laser measured" - reduces tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load equalization (rocker compensation)

Wheels and Tires
Kdodpfx Apsy Dzk Eszek
235 / 75 R 17.5"
manufacturer's choice
Factory silver steel rims

Braking System
2-line air brake system
Color-coded line routing for easy servicing
Manual spindle-operated parking brake
ABS and ALB, with ABS plug at front and connection cable
Attention: The trailer may only be towed by tow vehicles that ensure the operation of the ABS system!
2 foolproof coupling heads at the front, with connection lines to the truck

Electrics
24 Volt, multi-chamber lights, yellow LED side lighting
2 white front position lights
2 white/red lane control lights at rear
2 x 7-pin foolproof plugs at front, with connection cable

Hydraulics
Three-way tipper, hydraulic multi-piston press with lift limit and safety cable
Low-pressure cylinder up to max. 170 bar, without throttle. If necessary, retrofit on truck.
Hydraulic connection with SVK plug NW 10/3, including connecting hose
Operated hydraulically via truck PTO

Tipper Body
Sturdy tipper body with 4 mm steel floor, steel sidewalls, sides continuous, foldable and hung on pivots with central locking on bottom. Rear corner posts insertable. Rear wall foldable and hung on pivots, with central locking on bottom.
Body length approx. 5,000 mm, sidewalls with 6 bottom hinges.
Sidewall return springs (not available with split sidewalls)
Body width 2,420 mm
5 pairs of lashing rings in floor, each rated to 5 tons

Operating Notes
The stated gross vehicle weight is technically possible, but depending on the type of load, the total weight may not be achieved when adhering to permitted axle / support / saddle loads. (Poor driving and trailing behavior possible due to incorrect load distribution)

Country of Registration / Plates
Country of registration: Germany
with Dekra inspection and certificate (according to §13 EC - FGV)
24/7 service hotline
Prepared for single-line license plate holder
Outline marking with reflective strips according to ECE R 048, white on sides and red at rear

Paintwork
Frame hot-dip galvanized including passivation
"15-year warranty against rust-through"
Sidewall/body RAL 9005 deep black

Optional: Drive-on ramps €1,280.00 / net

Оголошення було перекладено автоматично. Можливі помилки перекладу.