Низькорамний причіп

MÜLLER-MITTELTAL T3 Tiefl., verz., Baggerstiel, hydr. Klapprampen

* T 3:
* EBS braking system
* Emergency release device for spring accumulators
* Drum brakes
* 3 x 11-ton BPW Eco axles
* Parabolic springs
Hsdpfx Aiotplwfsljnr
* Mechanical axle compensation at the rear
* Side impact protection
* Swivel supports at the rear of the chassis frame
* Mechanically adjustable warning sign panels at the front and rear
* Front axle with closed plastic mudguards and rear axle with straight, galvanized steel splash guards, each with splash protection
* Reflective contour strip on the sides and at the rear
* Folding cover (hot-dip galvanized) for the toolbox in the turntable platform
* Toolbox made of galvanized steel sheet, approx. 650 x 300 x 600 mm - black powder-coated - located on the side under the chassis
* 15-pin electrical connector
* LED lighting 12 / 24 V
* LED rotating beacon (removable) at the rear
* Drawbar with 40 mm towing eye and height adjustment via tension spring and locking clamp
* 4 lashing pockets on each side (but no lashing bars included) with simultaneous lashing capability
* Lashing package consisting of: 2 lashing eyes (6.4 tons) at the front left and right on the main frame of the turntable platform
* 5 pairs of UVV lashing rings, swivel and lowerable
* Load-bearing in all directions and embedded in the outer frame in the corners, 13.4 tons, otherwise 10 tons
* 6 pairs of mechanical folding outriggers for a total width of 3 meters (but not in the rear slope)
* Extension boards under the loading platform, stored in a storage compartment
* Excavator arm support over the rear axle up to the end beam, approx. 2,100 mm long (2 pairs of 6.4-ton lashing rings on the side in the excavator arm support)
* Hydraulic folding ramps (approx. 4,650 x 720 mm) with hydraulically extendable front section and load holding check valves, hydraulic lateral ramp adjustment
* Hydraulic flow divider in the trailer (for hydraulic pump output in the truck of more than 40 liters up to a maximum of 140 liters / min.), dual-line hydraulics
* Loading area above the slewing ring: approx. 1,960 x 2,520 mm
* Rear loading area: approx. 6,500 x 2,520 mm (incl. 860 mm access ramp)
* Loading height when loaded approx. 860 mm +/- 30 mm compensation unit
* Chassis, turntable, folding outriggers, rear support legs and access ramps hot-dip galvanized.
* Axles, springs, drawbar, air tank, etc. painted in a black tone.
* New vehicle with manufacturer's warranty
* Errors and prior sale excepted
* Available for immediate delivery from Egestorf

Оголошення було перекладено автоматично. Можливі помилки перекладу.