Низькорамний причіп

MÜLLER-MITTELTAL T4 40,0 , Agrar, hydr. Rampen,3 m. Paket

* T 4:
* EBS
* Emergency release system for spring accumulators
* Drum brakes
* 4 x 11 to. Gigant axles
* Parabolic springs
* Mechanical axle compensation at the front and rear
* Tire pressure monitoring system with display option in the truck via EBS signal - without installation on the truck side
* Warning sign packages at the front and rear
* Reflective contour strip on the sides and at the rear
* EBS multi-voltage system for 12 & 24 V electrical systems
* LED rotating beacon (removable) at the rear
* 24 V - 15-pin, as well as an additional 12 V - 7+4 pin - power cable
* Extended connecting cables for agricultural and forestry tractors
* LED lighting
* Straight drawbar with 40 mm drawbar eye and stepless height adjustment
* Toolbox made of powder-coated sheet steel and spare wheel holder in the body structure on the right side
* Closed plastic fender at the front
* Straight steel mudguards at the rear, each with splash protection (spray mist suppression)
* Side impact protection
* Extended offset overhang extended by 500 mm to the front
* Turntable platform extended by 520 mm with 45° corners and 3 recessed storage compartments including covers and lockable
* Chassis made of high-strength fine-grained steel
* Floor above the turntable platform made of 50 mm and in the low-loader platform made of 60 mm hardwood
* Outer planks of the loading ramps made of 50 mm bamboo wood
* 4 lashing pockets on each side (but no lashing bars included) with simultaneous 2 to lashing capability
* Lasi package consisting of: 2 lashing eyes, 6.4 to, at the front left and right on the main frame of the turntable platform, 1 pair of 13.4 to lashing rings on the outer frame on each side at the front and rear, as well as 4 pairs of 10 to lashing rings on each side, pivotable and lowerable, loadable in all directions and recessed in the outer frame, 2 pairs of lashing rings, 6.4 to, on each side in the excavator arm rest, 8 pairs of galvanized folding outriggers for a total width of 3 m (but not in the rear slope)
* Extension planks stored in a compartment on the left side
* Excavator arm rest above the rear axle to the end of the loading ramp, approximately 2,300 x 740 x 190 mm
* Mechanical support legs at the rear
* Hydraulic, hot-dip galvanized loading ramps, approx. 3,000 x 720 mm
Rodsl Th Evspfx Akgsu
* Hydraulic side ramp adjustment on sliding tube from the ramp shaft
* Loading area above the turntable: approx. 2,990 x 2,520 mm,
* Rear loading area: approx. 6,280 x 2,520 mm
* Loading height when loaded approx. 860 mm (including 860 mm loading ramp)
* Chassis, turntable, loading ramps, mechanical folding supports at the rear, hot-dip galvanized
* Axles, springs, air tanks and turntable painted in a black tone
* New vehicle with manufacturer's warranty
* Errors and prior sale are subject to change
* Available immediately from Egestorf

Оголошення було перекладено автоматично. Можливі помилки перекладу.