Напівпричіп-самоскид

STAS OP-V 11.40 63m³

Chassis Nickchassis cranked (approx. 80-100 mm lower)
Made of aluminum, high-quality ALU-MG-silicon alloy, two fully automatic welded I-beam longitudinal members with welded cross members. Chassis width 1,600 mm!

Axles and Suspension Wheelbase optimized for better trailing performance
Jost (DCA) axle units 22.5", 3 x 9 t axles with DCA air suspension, third axle liftable, first axle with start-assist and electric actuation (switch in tractor already available), raising and lowering valve for air suspension, Wabco SmartBoard.

Tyres and Wheels
6 wheels, tyres in size 385/65 R 22.5, approx. 50-60% tread on Alcoa aluminum rims, satin finish, ET 120, 11.75 x 22.5

Landing Legs
Mechanical landing legs with compensation feet, single-side operation design and 2-speed, 2x20 t support load

Brake System
According to E.E.C. standards, dual line system Westinghouse, spring brakes affecting two axles and Wabco EBS electronic system with RSS (Roll-Stability-Support), premium modulator, aluminum air tanks.

Electrical System
Built to StVZO regulations with 2x five-chamber lamps type Aspöck, 24-volt system with 2x 7-pin and 15-pin sockets, side LED contour lights, halogen RF Ix at rear and 1x on stand at the bulkhead separately switchable from outside, Volvo reversing camera (without tractor equipment), all air and electrical lines are neatly routed through plastic conduits!
Fjdpfexfn Drsx Aatepp

Tipper Body/Tipper Bin
Tipper bin fully welded inside, aluminum construction, side walls 30mm/600mm plank profiles, 3 mm inside, 2 mm outside, floor 8 mm extra reinforced wear-resistant (5383H34-HB110) and 45-degree profile, front wall 4 mm straight with interior access ladder, rear wall as double-wing door in straight design with 2 doors, 1/2-1/2 division, each with a grain chute, rear doors partly aluminum smooth cladding, rear crossmember foldable from ALU, two tie-downs with rubber buffer on tipper body fixed to frame at bulkhead,

Hydraulic System with Large Sleeve (new in 8.2025)
Hydraulic cylinder mounted on bulkhead with operating pressure of 150 bar, make Edbro 150 bar, approx. 2.5m hydraulic hose with quick disconnect 1", tipping angle approx. 48 degrees

Accessories
6 PVC mudguards with 2 rubber mud flaps at the rear, retractable splash flap on underrun protection, side impact protection according to StVZO, aluminum spare wheel holder, foldable underrun protection ALU with towing eyes, roof tarpaulin with side tension straps, 2 longitudinal tension straps from catwalk, 30 mm tarpaulin pipe welded centrally into the tarpaulin, rear tarpaulin rest made of aluminum sheet approx. 150 mm, 4 aluminum swiveling bows, 2 plastic toolboxes type 800, approx. 3 m aluminum ladder, catwalk on tipper body with access left and right, 2 plastic chocks with bracket on chassis, small pull-out ladder at rear, separate ALU discharge chute with tarpaulin sack, etc.

Offer and pictures are non-binding.

Оголошення було перекладено автоматично. Можливі помилки перекладу.